日本語
Winter windows | Updated October 2026

Your heat is
escaping through
the windows?
Window insulation film
is just right.

Hodoyo-kun

The short version…

  • About 58% of the heat lost in winter goes out through windows and other openings
  • Film adds a layer of air that cuts the chill and condensation
  • Water-applied sheets can't go on wired or Low-E glass (エコガラス). On double glazing, check the stamp in the bottom-right corner
Count the sheets you need ↓

Measure your windows: how many sheets you need

Measure just the glass (not the frame) and enter the width and height to see how many sheets you need. We calculate with the common 90 × 180 cm and 90 × 230 cm sheets.

80 cm
170 cm
2
Area to cover~2.7 m²
90 × 180 cm2 sheets
90 × 230 cm2 sheets

For each pane we cut as many 90 cm-wide strips as needed; short panes get two or more strips from one sheet. Trimming waste and re-dos aren't included, so buy one extra. Sheet sizes from Nitoms "Window Glass Insulation Sheet" specs (about 90 cm × 1.8 m / 2.3 m).

Hodoyo-kunHodoyo-kun
Measure only the visible glass. While you're there, check for a wire grid, and if it's double glazing, look at the stamp in the bottom-right corner (エコガラス or Low-E).

Want the details? (tap to open)

Who it suits, and who it doesn't

For cold, foggy windows. Some glass can't take film

○ Good for you if…

  • It's chilly near the window and the heating struggles
  • Your windows are dripping with condensation in the morning
  • You rent and want to fix cold windows without any work
  • Your windows are single panes of clear, smooth glass, or standard double glazing

× Not for you if…

  • Your windows are wired glass, Low-E glass (エコガラス) or vacuum glass
  • You want a crystal-clear view (it looks a bit frosted)
  • Drafts through the frame are the real problem
  • You want a real upgrade (consider inner windows or replacement)
Hodoyo-kunHodoyo-kun
Insulation film doesn't add heat. It keeps in the heat you've paid for. It helps whatever heater you use.

How it works, and glass you shouldn't cover

A layer of air on the glass. Careful with wired, Low-E and patterned glass

A single pane of glass is thin, so room heat passes straight through. Insulation film adds a layer of tiny air pockets, like bubble wrap, on the inside of the glass. The inner surface stays warmer, so condensation forms less, too.

Where heat escapes in winter Windows etc. 58% Other 42% (walls, air, floor, roof) Source: Japan Building Materials and Housing Equipment Industries Federation How the film works Outside (cold) Room (warm) glass air layer heat passes less easily

← Scroll sideways →

Glass you shouldn't cover (thermal stress cracks)

When sun hits the glass, the covered part and the part hidden in the frame can reach very different temperatures, and the glass can crack (a thermal stress crack). Glassmaker Nippon Sheet Glass warns that film or paper on glass can cause this. Sheet maker Nitoms also says it can happen with any glass, especially wired glass and vacuum or gas-filled double glazing. Before applying film to the glass types below, check the product's instructions.

GlassHow to tellInsulation film
Single clear paneSmooth, one layerMost films are OK
Wired glassA wire grid insideCracks easily. Don't use water-applied sheets; use a film on the frame (D)
Double glazing (ペアガラス)Two panes with a gapNitoms water-applied sheets are OK (if not Low-E). For other brands, check the instructions
Low-E glass (エコガラス), vacuum glass (真空ガラス) or heat-reflective glass (熱線反射ガラス)Mostly types of double glazing (heat-reflective glass can be a single pane). If the bottom-right corner says エコガラス or Low-E, it's this type. No marking, or not sure? Treat it as this typeRisk of cracking. Don't use water-applied sheets; use a film on the frame (D), or ask the glass or window maker or your landlord or management company
Patterned (frosted) glassBumpy on one sideWater-applied film won't stick to the bumpy side. Use a type for patterned glass

5 tips for choosing

Glass type, water-applied film, thickness, film for textured glass, long rolls
  1. First, check what glass you have

    Wired, Low-E and vacuum glass can crack. Standard double glazing is fine with Nitoms water-applied sheets. To tell whether double glazing is Low-E (エコガラス), look at the stamp in the bottom-right corner of the glass from inside; it may say so. No marking, or not sure? Treat it as Low-E and skip water-applied sheets. Always check "suitable glass" on the package or instructions.
  2. Renting? Choose a water-applied type

    It sticks with water, no adhesive, so it comes off easily (Nitoms says it "goes on neatly and comes off neatly").
  3. Choose by thickness

    A thicker air layer slows heat more. Nitoms, for example, sells a clearer ~2 mm type and a ~3.5 mm foam type. Thinner keeps more of the view; thicker is warmer.
  4. Bumpy glass needs a patterned-glass type

    Water-applied film won't stick to the bumpy side of frosted (patterned) glass. Use an adhesive type made for it.
  5. Tall windows: long sheets or rolls

    For floor-length windows taller than 180 cm, a 230 cm sheet or a long roll means fewer seams. Check the count with the tool above.

Pair it with insulating curtains

Gaps matter more than fabric thickness. Go to the floor and close off the top and sides

Window film only covers the glass. Cold air from the frame and gaps, and air chilled by the window that pours down onto the floor (a cold draft), can be cut by covering the whole window with a curtain. Japan's Agency for Natural Resources and Energy also says that for heating, thick, floor-length curtains work better.

Lots of gaps Fewer gaps Chilled air spills out Gap at the top Top closed off (curtain box) Floor length, sides turned back to the wall * Illustration

← Scroll sideways →

Even insulating curtains (断熱カーテン) depend on how you hang them

The Japan Association for Environment-Symbiotic Housing ran a simulation in FY2021 (a wooden detached house, curtains closed 6 pm–6 am). Simply hanging curtains barely reduced the heating load: about 0.4–1.8% in mild regions, almost no change in cold ones. But closing off the top with a curtain box (カーテンボックス) and turning the sides back to the wall (a "return") cut the heating and cooling load by about 15% in regions like Tokyo. The report found the gaps at the top and bottom mattered more than making the fabric thicker.

  1. Floor length

    Even for a waist-high window, a curtain that reaches the floor stops cold air spilling out underneath. Ready-made curtains (既製カーテン) come in many lengths, so measure from the rail to the floor.
  2. Wider than the window, wrapped around the sides

    Choose a width wider than the window. Bending the rail ends toward the wall (a return), or just letting the curtain rest against the wall, cuts the side gaps. Curtains with more pleats leave a thicker layer of air against the window.
  3. Close off the top

    A curtain box, or a cover over the rail (トップカバー), keeps warm air from escaping over the top.
  4. Treat "insulating" and "blackout" labels as a guide only

    There are still few figures comparing insulating fabrics under the same conditions, and the association above lists this as future work. Choosing by size and gaps first is the safer bet.
Hodoyo-kunHodoyo-kun
Keep heaters like oil heaters away from curtains. De'Longhi says to leave at least 20 cm from walls and curtains.

Common mistakes

Covering wired glass, a heater facing the window, and 2 more
Mistake: putting film on wired glass without checking
Instead: it may crack. On wired or Low-E glass, don't use water-applied sheets (use a film that attaches to the frame)
Mistake: it's still cold by the window after applying film
Instead: cold air also gets in through the frame and gaps. Add floor-length thick curtains (how to choose) or draft-stopper tape
Mistake: a heater in front of the window, blowing hot air on the glass
Instead: heating one part of the glass can cause cracks. Glassmakers warn not to blow heating or cooling air straight at glass
Mistake: applying it to dirty glass, so it peels right off
Instead: wipe the glass first to remove dust and grease

Good to know if you live in Japan

Japanese search terms, and keeping it removable in a rental
  1. Search in Japanese

    Window insulation sheet is 窓 断熱シート; water-applied is 水貼り; wired glass is 網入りガラス; double glazing is 複層ガラス or ペアガラス; Low-E glass is Low-Eガラス or エコガラス; vacuum glass is 真空ガラス; patterned glass is 凹凸ガラス or 型板ガラス.
  2. Renting: keep it removable

    Leaving marks on the glass could become a cost when you move out. Water-applied types are the safer choice; ask your landlord or management company if you're unsure.
  3. Sizes are in centimeters

    Sheets are usually 90 cm wide. Measure in centimeters before you shop.

FAQ

Can I use bubble wrap from packaging instead?
It adds an air layer, so it helps somewhat. But packaging bubble wrap is usually one-sided, and taping it up can leave marks on the glass. Window insulation sheets are mostly water-applied, with the air layer sealed between two films, so they look better and are easier to fit. Don't put it on wired glass either.
I applied it but can't feel a difference
Three common reasons: cold air through the frame and gaps (add curtains or draft tape), the sheet is thin (choose a thick foam type), and only part of the glass is covered (cover the whole pane).
What about summer?
Winter sheets can make glass heat up more in strong summer sun, and thermal stress cracks happen most on sunny windows. Peel them off when winter ends, or choose a product labeled for summer and winter.
Hodoyo-kun

Which heater is right for you?
Answer 7 questions and find the heater that's just right for you.

Take the heater quiz

Related guides